The scientific literature extensively mentions the use of a solar air heater (SAH) by utilizing solar energy for heating purposes. The poor heat-transfer rate of an SAH with a flat plate is caused by developing a laminar ...

Wire cut Electrical-Discharge Machining (WEDM) is a machining process which utilizes a thin wire (around 0.18mm) for material removal. In modern machining of complex object, it plays an important role. Process parameters ...

The main objective of this article is to perform the turning operation on an EN36B steel work-billet with a tungsten carbide tool, to study the optimal cutting parameters and carry out an analysis of flank-wear. Experimental ...

The objective of this study is to optimise the cutting parameters in Turning Operation. For this objective Taguchi Method was used. S/N ratio, ANNOVA was used to investigate the cutting force components & Material removal ...

Improvement in heat transfer rate and effectiveness of a solar air heater is always a matter of concern in the scientific community. Different steps have been taken to improve it, including the application of artificial ...

The effect of variation in open area ratio (β) in a multi-V rib roughened Single-Pass Solar Air Heater (SPSAH) is analyzed in this work. Fixing values of other parameters, such as open area ratio (β) and relative roughness ...

This study investigates the possibility of applying a large-scale solar updraft tower power plant in India with local ground conditions as an environmentally friendly and economically viable energy source. A reference ...

The marine ecosystem has a great potential for agricultural applications. Seaweeds are the most researched marine algae for various agrochemicals, pharmaceuticals, cosmetics, and biotechnological applications due to the ...

In this work, ZnO nanoparticles (NPs – L5 and L10) are biosynthesized using 5 mL and 10 mL leaf extract of Azadirachta indica, respectively. As-prepared L5/L10 NPs revealed hexagonal wurtzite structure while their surface ...